WDGAS58E Installation Kit for frequency-control lifts WDGAS58E with hollow bore (blind) encoder
The following installation kits are available for fitting the encoder to a
frequency controlled lift.
Every installation kit consists:
1 x Encoder, 1 x with 15 m ready-made shielded cable, 1 x shaft
adapter
Encoder type
Hollow bore (blind) Encoder WDG 58E
incl. torque support
Shaft
Material: stainless steel
Diameter: 10 mm
Starting torque
approx. 1.6 Ncm at ambient temperature
Max. operating speed
6.000 rpm
Permitted load on shaft end
max. 80 N radial
max. 60 N axial
Power supply
H24: 10 VDC up to 30 VDC HTL
R05: 5 VDC TTL with inv. output circuit
Pulses per revolution PPR
1024, 2048, 4096
Channels
H24: 3 channels, A, B and zero marker pulse N
R05: 6 channels, A, B, zero marker pulse N and inv.
Cable
Straight female connector with ready made cable.
The cable is 15 m in length and is shielded, however the shield is not
connected to the connector housing. With a mated connector, the encoder
meets protection class IP40.
Shaft adapters
Shaft adapters
10/M8
10/M10
10/M12
10/M16
10/M20
For further information please contact our local distributor.
