WDGAS58B Installation Kit for frequency-control lifts WDGAS58B
with shaft encoder
The following installation kits are available for fitting the encoder to a frequency controlled lift.
Quickly and reliably fitted with the aid of the accessories
Cost-effective modernisation solution
TTL, HTL output
Threads: M8, M10, M12, M16 und M20
Product details
Description
Every installation kit consists:
1 x Encoder, 1 x Mounting angle, 1 x shielded cable 15 m length,
1 x Double loop coupling, 1 x Shaft adapter
Encoder type
Shaft encoder WDG 58B
Shaft
Material: stainless steel
Diameter: 10 mm, H7
Lenght: 20 mm
Starting torque
approx. 1 Ncm at ambient temperature
Max. operating speed
8.000 rpm
Permitted load on shaft end
max. 220 N radial
max. 120 N axial
Power supply
H24: 10 VDC up to 30 VDC HTL
R05: 5 VDC TTL with inv. output circuit
Pulses per revolution PPR
1024, 2048, 4096
Channels
H24: 3 channels, A, B and zero marker pulse N
R05: 6 channels, A, B, zero marker pulse N and inv.
Cable
Straight female connector with ready made cable.
The cable is 15 m in length and is shielded, however the shield is not
connected to the connector housing. With a mated connector, the encoder
meets protection class IP40.
Mounting bracket
Mounting bracket MW58B
The mounting bracket makes for easy installation of the encoder in the
lift system. However care should be taken that the admissible load of
the coupling is adhered to.
